![]() We not only look at the problems you bring to our attention, but carefully evaluate the furniture for additional issues that could cause problems in the future. When you bring your patio furniture to The Southern Company, the first step in our process is a full inspection of the frame and seating. ![]() When that happens, the chair can be restored and updated with a new, fresh look. The first sign of wear would likely be sagging of the vinyl mesh, with possible discoloration of the mesh because of exposure to the sun and other environmental factors. Then pull up on the vinyl so you can slide it over the hole, as shown by this expert from our warehouse.Brown Jordan Avalon Sand Chair (photo courtesy of Similar issues would arise with Brown Jordan’s Avalon Sand Chair. Pop-in the rivet on one side, wrap it twice around the rivet and stretch it to the other side, but not over the hole, so you can wrap it twice and push in the other rivet. Push in a new plastic rivet through the hole on each end, both facing the same way. Use tongs or gloves to pull out one strap and immediately install it before it cools. It is not recommended to wear colored gloves as they can bleed colors from contact with the hot water. Remove the straps from the water using tongs, handle carefully with white gloves. Add 2-3 straps at a time in the hot water for 2 – 3 minutes. Do not allow the water to boil, but keep it just below bubbling. Prepare a pot of water that is about 200 degrees Fahrenheit. Step 4: Prep and Heat the Vinyl Strapping Start with one strap to be sure the length and tensionis correct. For example, if the total measurement is 30″, cut the straps to 25”. The vinyl straps stretch tightly once they are heated, so subtract 15% of the measurement from your cut. Hold a measuring tape over the rivet hole on one side, wrap it twice around the frame, and pull it across and wrap it twice around the other frame, and take the measurement at the center of the other hole. Our strap chairs and chaise lounges are double wrapped around the frame. Step 3: Cut and Measure Straps: Skip this step if you ordered pre-cut straps! It is recommended to bolt down the chair or place something heavy on bottom rails of the chaise lounge or chair to keep it secure while you work. Unravel the straps from the chair or chaise and pop out the old rivets. Use scissors to cut through the old vinyl straps. Step 2: Cut & Remove the Old Vinyl Chair Straps Some of our most popular strap chairs and chaise lounges include the RP1003, RP1001, RP5001, and the RP5003. Take a look at our Vinyl Strap Chaise Lounges and Commercial Vinyl Strap Chairs to find your chair. If you have ordered your strap furniture from us, we can look up your order and confirm the model number of your chair to measure and cut the straps for you. Each roll contains 200 feet, or about 90 straps. There are two options for ordering replacement straps: We can pre-measure and cut the straps for you, or you can order a roll and cut and measure yourself. If you have any questions about how much strapping you need don’t hesitate to give us a call. The amount of strapping required depends on the length of the chair or chaise. Step 1: Order the Replacement Straps and RivetsĬall our friendly staff at 1.877.646.6320 to order replacement straps and rivets. Our commercial pool straps come in a variety of colors to match most outdoor furniture and are made of 100% virgin vinyl to last for years in a commercial environment. Don’t throw out your commercial grade chair or lounge – replace the straps to extend the life of your pool furniture at a fraction of the cost! The vinyl straps on chaise lounges and chairs become oily and stained from suntan lotions, dirt, and weather. Commercial strap pool and patio chairs last many years before they start to weaken.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |